Hi to you all!
I´m new to the reflector and I´m seeking for advice, opinion and hints
on the following:
I own an old amp based on four grounded grid 811 tubes. One of them went
dead so I believe it´s time to look at it before installing the quad set
a friend brought from the US (from RF Parts).
The input to the cathodes is untuned. I know the amp was designed for AM
use. Would it increase linearity by an usable margin to include pi
networks on the input? (I only operate CW and SSB). I would probably
have to build the pi filters on a separate box with another band switch
or add a wafer to the existing one and a bunch of relays . Also, the amp
has some neutralization, a small variable capacitor between the plates
and a link made of few turns over one of the cathode chokes. Is this
really necessary? The amp tunes the 5 pre WARC bands; what may I expect
from it on the new 3 using the closest frequency band switch position?
How about either adding 160 or 6 meter coverage?
The HT is about 1500 V under full load. Any further ideas on
improvements?
I thank your time
73
Joao Kolar De Marco, PY2FCE
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|