-----Original message-----
From: wb8jkr@juno.com <wb8jkr@juno.com>
To: AMPS@contesting.com <AMPS@contesting.com>
To: <amps@contesting.com>
Date: 30 oktober 1998 13:20
>
> Anyone,
>
>
> Ok, Ok, I can't stand it. It may be a dumb
>question but just what is the 'G2DAF' design,
>and the principles behind it?
>
>Mark WB8JKR
Ok, Here are the basic principles of G2DAF design:
1.) It uses one or more tetrodes.
2.) It has a conventional outputside; pi- or pi-L-filter.
3.) The unique thing is the inputside, wich is a methode to obtain both screen
voltage and griddrive from
the very same source; Your exciters RF-output!
4.) The class of operation is FLOATING and not FIXED as with most other amps.
Facts wich applies to
tetrodes with FIXED class of operation, for example Eimacs statements on
screenregulation versus
linearity, does NOT apply to this amp and this class of operation.
To achieve the above, the technique is to feed a small part of the the
drivepower to the grid of the tube and
the mainpart thru an RF rectifier, voltagemultiply it and feed it to the
screen. Some measures must be taken
in order to get an appropriate balance between grid- and screendrive.
Then, why use this circuit?
1.) Simple design. No screen- or biassupply is required.
2.) High gain. Up to 20dB. Low drive requirements.
3.) Efficiency. Higher pulse power than with other circuits. Tube is almost cut
off with no drive.
4.) Finally, and appearantly most controversial, very good linearity - proven
by means of on air tests
as well as plots from HP spectrumanalyzer, using speech (NOT 2-tone
Rich..!)
"Life is to short for QRP"!
73 de Lars/SM3BDZ
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|