Amps
[Top] [All Lists]

[AMPS] Electronic Bias Switching

To: <amps@contesting.com>
Subject: [AMPS] Electronic Bias Switching
From: paulc@mediaone.net (Paul Christensen)
Date: Mon, 28 Dec 1998 16:27:23 -0500
Rich,

Thanks for your reply.  As is almost always the case, there are trade-offs
associated with every change, some more obvious than others.

-Paul, W9AC

-----Original Message-----
From: Rich Measures <measures@vc.net>
To: [AMPS] submissions <amps@contesting.com>
To: <amps@contesting.com>
Date: Monday, December 28, 1998 1:04 PM
Subject: Re: [AMPS] Electronic Bias Switching



>
>As I was searching through the database of my new QST collection on CD-ROM,
>I found an interesting suggestion from an old acquaintance and mentor of
>mine, Barry Boothe, W9UCW of "The Minooka Special" fame.
>
>In a mid-70s issue of QST, Barry describes a unique method of implementing
>EBS to his homebrew amp.  Rather than employ bias to the cathode, as is
>common in the ETO line of Alpha amps and perhaps others, he applies bias to
>the control grid in a GG configuration, by placing a pair of 0.01 uF mica
>from the grid to ground, and impresses negative bias to the control grid
>with the commonly-found darlington transistor pair who's bias is driven
from
>the amp's input RF sample.  From an R.F. perspective, the tube remains
>grounded, yet allows for D.C. bias.  It's a single-state switch, but the
>point to be made is that EBS bias is applied to the grid rather than the
>cathode, thus eliminating the need for complicated protective measures
>between the EBS circuit and the cathode.
>
?  However, some various fault possibilities.
1.  A gas flashover in the tube due to a leaky seal.
2.  The anode touches the grid (some 3-500Zs)
3.  An intermittent vhf parasite generates a large burst in grid-current.

-  -  Each of these faults makes the grid dangerous to an EBS, so rugged
protective measures would still be necessary.  //  Another issue is
RF-input actuated transmit/receive bias switching.  A friend recently
purchased such an amplifier (a 91B), and it generates a pecuilar type of
IMD as the amplifier rapidly switches from Tx-bias to Rx-bias between
syllables of speech.    At the risk of being boring, I believe it is a
mistake to allow the bias to switch to Rx (cut-off) mode at any time when
the amplifier relays are in Tx mode.

-  later, Paul.


Rich...

R. L. Measures, 805-386-3734, AG6K, www.vcnet.com/measures


--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm




--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>