Rich Measures wrote:
>>Coming back to the roller coils, Rich makes a good point that *if* the
>>material has bubbled internally, that suggests internal RF losses as
>>well as external heating by contact with hot metal.
>>
>? Ian: I did not and do not suggest that heat from contact with the
>wire causes any of the Delrin bubbling observed by users of MFJ tuners.
Yes, it is clear that external heating could not cause the internal
bubbling.
>>In the end, the only way to find out is to try it.
>
>? I found out that Nylon, PVC, and Delrin had a Dissipation-factor
>problem by reading the specs. on them at the local plastics supply house.
>
But that tells you nothing about whether they will work well enough in a
particular situation.
>> For situations where
>>an inexpensive and easily machined material such as Delrin is proved to
>>work, there's no point in paying for PTFE or ceramic.
>>
>? There are many applications where Delrin would be better than PTFE or
>ceramic. RF-applications is not one of them.
As Dick has pointed out, there are many non-demanding RF applications
where Delrin can do the job adequately. For those applications, Delrin
works just as well as PTFE or ceramic would.
73 from Ian G3SEK Editor, 'The VHF/UHF DX Book'
'In Practice' columnist for RadCom (RSGB)
http://www.ifwtech.demon.co.uk/g3sek
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|