>
>In message <19990301180059.AAB15127@[209.239.238.104]>, Rich Measures
><measures@vc.net> writes
>>
>>>
>>>One caveat on adding FETs in shunt to get the power handling up in a screen
>>>grid shunt regulator that I didn't see on Rich's web page (but I could have
>>>missed it) is that you need to make sure they share the current equally.
>>>Series resistors in the source are a good way.
>>
>>? I do not use FETs in the screen shunt-regulator. I use FETs in the
>>screen series-regulator. In the latter, I use Source (neg. feedback)
>>resistor(s) as current-equalizers and to suppress osc. around 100MHz.
>>- cheers
>>
>>
>>
>>Rich...
>For belt and braces against oscillation, a few ohms right by the gate
>(just like a grid stopper) will rarely cause any harm.
>
? I use one. See R13 in Figure 8 (screen reg.) on my Web site. .
- cheers, Steve
Rich...
R. L. Measures, 805-386-3734, AG6K, www.vcnet.com/measures
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|