Amps
[Top] [All Lists]

[AMPS] Ripple Current

To: <amps@contesting.com>
Subject: [AMPS] Ripple Current
From: km1h@juno.com (km1h@juno.com)
Date: Thu, 11 Mar 1999 12:23:22 -0500


On Thu, 11 Mar 1999 14:37:05 -0000 Peter Chadwick
<Peter_Chadwick@mitel.com> writes:
>
>Assuming the doubler is the 'full wave' one (i.e. two caps in series 
>shunted
>across two diodes in series, with the ac between the junction of the 
>caps
>and the junction of the diodes) each cap gets a charge every other 
>half
>cycle. In the intervening half cycles, it gets a discharge. So the 
>ripple
>current in the capacitor is the same frequency as the supply. The 
>heating
>effect (which I guess is the bottom line) is then the rms equivalent 
>of the
>charge current plus the rms equivalent of the discharge current, all
>squared, times the ESR at the line frequency. 
>
>I'd guess that the ripple current rating should be much the same at 50 
>as at
>100Hz (or 60 and 120)



Tnx Peter.

I seem to remember Tom Rauch commenting about extra capacitor stress in a
FW doubler compared to a FWB. Also remember a rather heated discussion
amongst the engrs at National that resulted in them ordering special HD
rated caps for the NCL-2000.

Oh well.

73  Carl  KM1H


___________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
or call Juno at (800) 654-JUNO [654-5866]

--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>