Hello:
A friend of mine has one of the first manufactured PT2500 Amplifiers
manufactured by B&W. He would like to know if there were any major changes
made in the power supply. He is not sure of what the Load /No Load Plate
voltage should be. The manual said 3800 Volts, but this was lined out and
it said 3450V Exactly what his meter reads. The actual voltage measured
with a high voltage and a Fluke meter lower.
I would like to know what the typical power output and plate voltage
should be for these amplifiers, and if anyone knows if the earlier designs
produced less power output.
brad
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|