Amps
[Top] [All Lists]

[AMPS] TL-922 Filament Transformer Protection

To: <amps@contesting.com>
Subject: [AMPS] TL-922 Filament Transformer Protection
From: measures@vc.net (Rich Measures)
Date: Tue, 8 Jun 1999 08:52:28 -0700


>
>Tom says:
>
>>One cure is to park the resistor outside the suppressor coil, and 
>>series tune it with a small mica cap. That not only increases 
>>current through the resistor at VHF, it decreases resistor current at 
>>HF. 
>
>Another method which is very effective at reducing the current in the
>resistor is to use a one or two turn link in the plate circuit, coupled to a
>parallel resonant tuned circuit tuned to the parasitic frequency, with a
>resistor across that. As in the older editions of the ARRL handbook. It also
>allows tuning out the reactance of the resistor.
>
>I suspect that winding the choke over the resistor was a practice started
>when resistors were generally either carbon composition or the earlier
>carbon rod types, which were essentially non inductive; it saved space.
>
>>Since inexpensive non-inductive carbon resistors are getting nearly 
>>impossible to find
>
>Even EXpensive ones seem impossible to find!
>
?  There is no such thing as a non-inductive resistor.  



Rich...

R. L. Measures, 805-386-3734, AG6K, www.vcnet.com/measures  


--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>