Sorry, guess I should have said that it was all bands 160-10 meters. According
to the manual copy I have, 200ma grid current is the max that is ok, I can vary
it up and down with drive also. Tuning and loading looks to be within range, if
anything, the load control likes to see more C. Power meter is ok, Has never
had any glitches with the older sb200's on it. It's dead nuts on too at 500
watts. I'm driving the amp with a ts930, so there's plenty of soup, I can give
it up to the recommended 80 watts, but have only given it 60 watts so far, as
that's where the grid current maxes out at 200ma.
Thanks,
Scott
>At what frequency? 450mA at 1500V is only 700W input so 500W output is
>rather good. I assume from the grid current, you have it loaded wrongly,
>but that might be right for the 811A. You should have much more plate
>current.
>
>1. Are the tuning and loading capas still within range.
>2. Is your power meter OK - seems rather generous.
>3. Do you have enough drive and is it getting to the bases.
>
>
<bold><bigger>
Advantage Communications
</bigger></bold>Professional Wireless Communications
www.radiosonline.com
800-851-RADIO
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|