Amps
[Top] [All Lists]

[AMPS] MFJ-259

To: <amps@contesting.com>
Subject: [AMPS] MFJ-259
From: wsz@ginko.de (Werner S. Zielke, DJ2HZ)
Date: Mon, 11 Oct 1999 04:25:04 +0200
Does anyone have suggestions to calibrate the MFJ-259?
Or does anyone have a schematic diagram of it? I was asking the manufactory
and they gave me the tip the calibration is off. My question to MFJ what I
have to do without any schematic diagram is ignored. No response...

Cheers,

Werner
DJ2HZ



Subject: 
          Re: MFJ-259
To: <amps@contesting.com>
    Date: 
          Wed, 06 Oct 1999 08:50:00 -0500
    From: 
          Jim Shurden <jshurden@mfjenterprises.com>
      To: 
          wsz@ginko.de (Werner S. Zielke)




Dear SIr,

Sounds like the calibration is off.

Thank You,
Jim Shurden
MFJ Customer Service

==============================================================
At 04:20 AM 10/06/1999 -0500, you wrote:
>Below is the result of the WWW feedback form.
>
>Dear Sirs,
>I'm using MFJ-259. With an 50 Ohms resistor (non inductive)
>swr = 1:1 and the meter shows 50 Ohms. Using a 25 Ohms resistor
>the meters shows 1.7:1 and 19 Ohm, using 100 Ohms resistor swr = 1.8:1
>and 80 Ohms. What is the matter? Is the calibration off?
>An analyser of another producer shows the correct readings.
>
>Best regards,
Werner, DJ2HZ 
>
>



--
FAQ on WWW:               http://www.contesting.com/ampsfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>
  • [AMPS] MFJ-259, Werner S. Zielke, DJ2HZ <=