>
>Hello Pete:
>
>I usually start my parasitics hunt with the old Millen grid dip meter and
>the amp disconnected from the mains. You will be surprised how many odd
>resonces there may be.
>
>If you find a resonant frequency in the grid or cathode circuitry try to
>rotate your C1. If there is a change in the dip you may have a tgtp
>oscillator at that frequency.
>
>Also I try to parasitic test my amplifiers with higher then normal resting
>current. The small signal gain will be higher and any tendency for
>parasitics will be increased.
>
>I never tried this on a SB220 but could there be some new resonant
>frequencies in the 3-500Z grid circuitry?
There are, in the 88MHz range.
>The paralell circuit of the
>negative feedback condensers and grid chokes maybe are resonant somewhere?
Direct-grounding the grid makes little change in the resonance.
>And the plate choke maybe has the same resonant frequency? Maybe you tried
>earlier to run the amp on one of the bands not avaible the SB 220 and one
>of the grid chokes was hurt by a parasitic and changed its self resonant
>frequency?
The grid RFC is essentially bypassed at the parasitic freq. of c. 110MHz
by the (3) 200pF grid capacitors.
>If I remember right, the new bands where not avaible in 1968-69
>when the SB 220 came out and the plate choke nay very well be resonant on
>the newer bands?
The HV-RFC is resonant above 35MHz.
>
>...
cheers, Hans.......
- Rich..., 805.386.3734, www.vcnet.com/measures.
--
FAQ on WWW: http://www.contesting.com/ampsfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|