Assuming a transformer turns ratio of 11, a 10 ohm
25 to 30 watt wirewound in the filament transformer
primary would probably put you very close to the right
voltage.
Mark WB8JKR
On Fri, 18 Feb 2000 17:48:54 -0800 Ed Diyorio <k6odv@clubnet.net> writes:
>
> Looking for information concerning reduction of filament voltage on
> the
> 2K-2 amp. I have a amp with 11.29 volts???
>
> Thanks for your help. Ed, K6ODV
>
________________________________________________________________
YOU'RE PAYING TOO MUCH FOR THE INTERNET!
Juno now offers FREE Internet Access!
Try it today - there's no risk! For your FREE software, visit:
http://dl.www.juno.com/get/tagj.
--
FAQ on WWW: http://www.contesting.com/ampsfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|