Amps
[Top] [All Lists]

[AMPS] Filament current

To: <amps@contesting.com>
Subject: [AMPS] Filament current
From: plantin@att.net (plantin@att.net)
Date: Mon, 21 Feb 2000 16:36:02 +0000
Hi all, 
I just put filament voltage to my new 8169 tube for a 
little burn in time.
To my surprise, the filament appears to drawing about 48 
or 49 amps instead of the data sheet 42 amps with 9.00 
volts at the socket.
Should I be concerned? Could this be the norm for a new 
tube, then after a few hours, it will drop back to the 
42 amps?
Any informed insight would be greatly appreciated.
--
Regards,
Bruce W3BP
                        

--
FAQ on WWW:               http://www.contesting.com/ampsfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>