Amps
[Top] [All Lists]

[AMPS] Shorted Pi-Network Turns

To: <amps@contesting.com>
Subject: [AMPS] Shorted Pi-Network Turns
From: philk5pc@tyler.net (Phil Clements)
Date: Sun, 10 Sep 2000 16:23:50 -0500
> The SB1000 had about 50 times the switch failures (as determined
> by parts shipped to customers) of the nearly identical AL80A.
>
> The reasons were:
>
> 1.) A looser spec on the transformer no-load to full-load voltage
> change.
>
> 2.) No buck-boost winding to adjust power line voltage.
>
> 3.) No anti-corona washer at an area in the switch where voltage
> gradient is a problem.

Not true in all cases. The last SB-1000 I built had specific instructions
in the manual on installing the washer. The band switch crispy-crittered
anyway.

>
> 4.) No control over assembly and wiring, including relay contact
> adjustments.


5.) Improper component selection in the padder caps.
      (this one added by K5PC)


(((73)))
Phil, K5PC







--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>