Amps
[Top] [All Lists]

[AMPS] AL-80B

To: <amps@contesting.com>
Subject: [AMPS] AL-80B
From: 2@vc.net (measures)
Date: Wed, 27 Sep 2000 14:24:04 -0700
>
>To:                    <amps@contesting.com>
>Subject:               [AMPS] AL-80B
>Date sent:             Wed, 27 Sep 2000 12:39:05 -0400
>
>> 
>> And, I can see why you guys fight so much on the reflector.  No
>> where did I say that we stuck our hand inside the live amp, that is
>> why they have a meter switch to observe the voltage with the cover
>> closed.  It was an examination of the drawing that revealed that this
>> was the normal condx for that amp.  Anyway, I am not looking for
>> any comments back from the normal few.  Thanks again.
>You would depend on a voltmeter reading to save your life???   I would 
>NEVER put my hands inside an amp without first disconnecting (and 
>then checking again to make sure it is disconnected) the primary AC 
>power, and then shorting B+ with a shorting stick in case a bleeder 
>resistor failed.
>
Shorting charged filter caps with a shorting stick often results in 
destruction of amplifier parts.  Better to put a 100w  resistor in series 
with the shorting stick.  

>.....

end

-  Rich..., 805.386.3734, www.vcnet.com/measures.  
end


--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>