>
>I have plan to build Amplifier for SSB using 4 x RS1007 tube (same with
>4-125A or QB3/300). It will be employed in AB1 with 600 volt in screen
>and 2500 volt in plate and using passive Grid with 50 ohm non inductive
>resistor in grid to avoid neutralizing.
>
>How much (watt) will be approximate required to drive this amplifier ???..
>
You can figure this from Ohm's Law if you know the bias volts. For
example, 100w pep/50-ohms = 100v-pk
>Thanks
>Firson - YD1BIH
>_________________________________________________________________________
>Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
>
>Share information about yourself, create your own public profile at
>http://profiles.msn.com.
>
>
>--
>FAQ on WWW: http://www.contesting.com/FAQ/amps
>Submissions: amps@contesting.com
>Administrative requests: amps-REQUEST@contesting.com
>Problems: owner-amps@contesting.com
>
>
- Rich..., 805.386.3734, www.vcnet.com/measures.
end
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|