Amps
[Top] [All Lists]

[AMPS] SB200 SoftKey Instructions

To: <amps@contesting.com>
Subject: [AMPS] SB200 SoftKey Instructions
From: 2@vc.net (measures)
Date: Wed, 11 Oct 2000 20:25:12 -0700
>
>I recently picked up one of the Harbach softkey units from a private party,
>but he was unable to supply the installation instructions.  does anyone have
>the procedures?  Will pay for copying/postage.
>
>Also, general question...
>In the process of rebuilding the power supply board of the same sb200 and
>would like comments on the replacement of the equalizing resistors across
>the filter caps and the two other associated higher wattage resistors.

The orig. 30k bleeder resistors get so hot they blacken the phenolic 
circuit board.  Replace them with 100-k 3w MOF resistors to stop the 
toasting problem. 
end

-  Rich..., 805.386.3734, www.vcnet.com/measures.  
end


--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>