Amps
[Top] [All Lists]

[AMPS] getters

To: <amps@contesting.com>
Subject: [AMPS] getters
From: 2@vc.net (measures)
Date: Tue, 17 Oct 2000 23:22:05 -0700
>
>> You have me curious about something.  I recently fired up my old Heath
>> SB-1000 after it sat idle for about six years.  It was fine when put in
>> storage, but when powered up, the 3-500Z lit up like one of those Radio
>> Shack globes with the "lightning" effect.  I replaced it and all was well.
>> 
>> My question is, has this tube gone permanently bad or could it be
>> revived with carefully controlled "gettering"?  I have a suspicion if
>> there is that much gas in there, it's gone for good.  Any one have
>> experience of this sort?
>
>If you can heat the anode by running the tube at low anode voltage 
>and forward grid bias, and let it cook, sometimes they will getter 
>out the gas.
>
>I've been successful quite a few times doing that with old 3-500Z's 
>that weren't too badly gassed.
>
>Another way to getter the tube is through a current limited arc. 
>Sometimes that's done with new tubes. I haven't tried that myself.
>
sea stories

end

-  Rich..., 805.386.3734, www.vcnet.com/measures.  
end


--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>