Depends on the Plate voltage, but typically
I'd say about 1200-1300 ohms at 2KV or so.
Mark WB8JKR
On Mon, 23 Oct 2000 18:13:06 -0400 "Ed W3NR" <w3nr@vol.com> writes:
>
> Plate load impedance for 4-572's ??? I don't see it anywhere in any
> info I
> can find on the Net. Any help....thanks
> Ed W3NR
>
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/amps
> Submissions: amps@contesting.com
> Administrative requests: amps-REQUEST@contesting.com
> Problems: owner-amps@contesting.com
>
________________________________________________________________
YOU'RE PAYING TOO MUCH FOR THE INTERNET!
Juno now offers FREE Internet Access!
Try it today - there's no risk! For your FREE software, visit:
http://dl.www.juno.com/get/tagj.
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|