To: <amps@contesting.com>
>Date: Thu, 25 Jan 2001 20:27:33 -0600
>To: "Roger D. Johnson" <n1rj@pivot.net>
>From: Bill Aycock <baycock@HIWAAY.NET>
>Subject: Re: [AMPS] Clipperton help
>In-Reply-To: <3A70DC56.75F2F3F3@pivot.net>
>References: <3.0.5.32.20010125172039.019e0420@HIWAAY.NET>
>
>Roger- this appears to hold for tuners. However, the manual for the
Clipperton says:
>
>" When tuning the Clipperton-L on 10 meters keep the loading control
above #5 at all times"
>
>#5 is about half meshed, and higher numbers are less capacitance.
>
>Bill-W4BSG
>
>At 09:09 PM 1/25/01 -0500, you wrote:
>> I seem to recall that the proper way to tune amps. that
>>were a bit less than stable, was to always start with the
>>loading capacitor fully meshed. Perhaps some of our
>>amp gurus can shed some more light on this practice.
>>
>>73 Roger
>>
>>
>>
-
Bill Aycock --- Persimmon Hill
Woodville, Alabama, US 35776
(in the N.E. corner of the State)
W4BSG -- Grid EM64vr
baycock@HiWAAY.net
w4bsg@arrl.net
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|