> Anyway I replaced the transformer with a Peter Dahl and now rather than the
> 2400V resting plate voltage I get 3000V. The problem I am seeing is that with
> even 7V of negative grid bias I get a no signal grid current of about 160mA
> and plate current of about 200mA. With the original transformer the grid
> current was near zero.
Adjust the bias until meter readings return to factory specs.
Check for proper filament voltage at the tube pins...this may be high also......
GL!
Phil, K5PC
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|