Amps
[Top] [All Lists]

[AMPS] Checking out old amp

To: <amps@contesting.com>
Subject: [AMPS] Checking out old amp
From: jflanders2@home.com (Jerry Flanders)
Date: Fri, 16 Nov 2001 12:59:07 -0500
Should I worry about damaging the output tube?

I need to power up this old 5CX3000A pentode amp in a limited way to 
proceed with my checkout. I am nowhere near to applying HV and drive yet, 
but think I have the bias and SG supplies operational and need to check out 
a few voltages and circuits. There is a ton of supporting/protective 
circuitry that I want to observe and try to understand (no schematics).

I am concerned about powering up the main tube because I read warnings 
about operating without plate HV, but perhaps this doesn't apply as long as 
there is no drive.

As far as damage to the big tube is concerned, should I be worried about 
damage to it if I power up all but the drive and HV? I KNOW I have bias on 
grid 1. I am not sure the screen grid actually has voltage until I smoke 
test, because it looks like that circuit is awaiting some relays to pull in 
that probably will in this next step. Any tips/advice/whatever?

Thanks

Jerry W4UK


--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>