Guy's...
Started this project some time ago but I just cant get the time to finish
it (business picked up finally).
Gathered most of the parts. The tank coil needs wound (1/8" copper tube)
and there are some odds and ends necessary to complete the parts list (disk
ceramics, etc)
What I have is:
Clean SB-200 with the band switch and all the tank circuit removed
The original front panel and a new front panel cut for the meter and the
new caps
Original meter and knobs
The tune cap
The load cap
blocking caps
two required chokes
A good 3cx800a7 with socket and chimney
Filament TX for the tube
ARRL 92 HB article for 6M amp using this tube
The 3cx800a7 socket will fit in one of the 572B holes.
The HV power supply is more than adequate
Cost $595 plus shipping
Norm N8NH
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|