Amps
[Top] [All Lists]

[Amps] Bird PEP board

To: <amps@contesting.com>
Subject: [Amps] Bird PEP board
From: kl7ra@blizzard.gcgo.nasa.gov (KL7RA)
Date: Fri, 3 May 2002 07:37:08 -0800
----: Re: [Amps] Bird PEP board


Hi Roger

I have a Peak reading circuit for a Bird using an op amp
with a battery. To solve the battery drain I used a DPDT
switch and when I'm in "average" position the battery is 
out of the circuit.

73 Rich KL7RA
 



> The mystery of the "Battery Eating Bird" has been solved! I drew
>out the circuit and found that each battery has a Zener shunt
>regulator circuit associated with it. A 6.2 volt Zener through
>a 150 ohm resistor! The damn regulator gobbles up about 18 ma
>to regulate 2ma for the IC! The engineer that designed this must
>have worked for Eveready. 
> I'm wondering if this circuit really has to be regulated at all.
>If so, perhaps a low dropout series regulator would be much more
>efficient.
>
>73, Roger
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>


<Prev in Thread] Current Thread [Next in Thread>