>How about a 3CX1200?
The new 1200Z7 is less squirrelly than the old A7 version, but the
filament V & I needed is higher than a 3-500V.
>There are many articles about converting 3-500 based
>amps to this tube. It should be the same for
>the 3-400 as well.
>
The 8877 has a 5v heater, the same anode V-rating, c. the same drive
requirement, but about 40% of the input Z. At the Rx end, it would do
about half of a std 6db S-unit mo' betta.
>
>----- Original Message -----
>From: "Bill Smith" <ko4nrbs@yahoo.com>
>To: <amps@contesting.com>
>Sent: Thursday, May 16, 2002 10:33 AM
>Subject: [Amps] 3-400Z Tube Replacement ideas
>
>
>> Other than the 3-500Z or 3-500ZG what tubes would be
>> suitable to replace a couple of 3-400Z tubes?
>> 73,
>> Bill
>>
>> =====
>> Bill Smith KO4NR
>>
>> __________________________________________________
>> Do You Yahoo!?
>> LAUNCH - Your Yahoo! Music Experience
>> http://launch.yahoo.com
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>>
>>
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>
- R. L. Measures, a.k.a. Rich..., 805.386.3734,AG6K,
www.vcnet.com/measures.
end
|