>My Mark 1 meter will not indicate anything at all. I
>have traced all the wiring throughout and did
>continuity checks but can't find anything wrong. How
>can I test the meter without damaging the movement? I
>did use an ohm meter set on it's lowest scale and got
>the meter's hand to go up.
Apply a known current through the meter current shunts resistors and
check the accuracy of the grid and the plate/anode current meters.
- R. L. Measures, a.k.a. Rich..., 805.386.3734,AG6K,
www.vcnet.com/measures.
end
|