I have had good success with Vector FR-4 Epoxy perfboards. I have used both
the press in pins and just having the leads go through the board and
soldering them together on the other side.
73 de Mike, W1NR
----- Original Message -----
From: <RMead100@aol.com>
To: <amps@contesting.com>
Sent: Friday, June 14, 2002 2:02 PM
Subject: [Amps] HV Circuit Board Material?
> Greetings to the list
>
> Since I am going to be rebuilding my L7 Power supply, I am thinking about
> trying my hand at a simply circuit board fabrication for the two boards
that
> mount on each side of the L7 PS and hold four caps and the equalizer
> resistors plus the diodes.
>
> Is there any good operational/safety/durability reason not to do this?? If
> the answer to that is a go, does anyone have a suggestion for the basic
type
> of PC board stock I should order, ( and where I might buy it?)
>
> Thanks to all
> Randy
> K8BUX
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
|