> Hi,
>
> I have a bunch of NOS meters I've collected over time.
> I'd like to use them in a new 6m amp I'm putting together, so
> I need to make some shunts...
>
> Anyone know of a procedure where I can determine the internal
> resistance without damaging the meter movement? or, am i SOL?
> Some are uA meters, some volts and some watts -- so who knows what
> the intended range was.
>
[Steve Katz] They'll all be uA or mA meters, unless there's already
a shunt or multiplier resistor inside the meter case. I use a VOM, start
with a high resistance range and dial it down to lower ranges, haven't blown
a meter winding yet. -WB2WIK/6
> Thanks,
>
> Gerry, W1VE
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
|