Amps
[Top] [All Lists]

[Amps] Stainless

To: <amps@contesting.com>
Subject: [Amps] Stainless
From: 2 at vc.net (2)
Date: Fri Feb 28 12:44:03 2003

>Non-magnetic stainless steel alloys will work. Some are magnetic, as 
>can be tested with a small magnet. These are the higher loss 
>stainless steels, in which eddy current heating can be expected. 
>Brass is certainly preferred, but for strength, it is not so good 
>compared to SS. We try and use brass in big amp cabinets here, but 
>sometimes are forced to use nonmag stainless bolts. They do work. By 
>the way, nickle plated brass hardware is very common for usage also.
>
>Building side panels and chassis of stainless steel sheet is a way to 
>lower the Q of your amplifier, unfortunately.
>
**  is lower Q always undesireable?  In the Henry 3K-A, the occasional 
instability at c. 95MHz appears to be supported by the high-Q resonance 
of the (Al) enclosure.

-  R. L. Measures, a.k.a. Rich..., 805.386.3734, AG6K, 
www.vcnet.com/measures.  
end

<Prev in Thread] Current Thread [Next in Thread>