Ian, you are completely correct about your Triode board. The delay
circuitry is only a minor part of the board. I am thinking about building
up a tetrode amp and one of your boards will definitely be included in the
design. I apologize for the misunderstanding I may have created. It was
unintentional.
73
Bob W6TR
----- Original Message -----
From: "Ian White, G3SEK" <G3SEK@ifwtech.co.uk>
To: <amps@contesting.com>
Sent: Sunday, April 06, 2003 1:50 PM
Subject: Re: [Amps] G3SEK Triode Control Board
> Bob Maser wrote:
> >Anyone interested in a G3SEK Triode control board. It is completely
built
> >and tested. I planned on using it with a 8877 amp but I changed the tube
to
> >an instant on filament tube, I no longer have a need for it.
>
> Please forgive this comment about my own product, but the message above
> could leave an incorrect impression.
>
> An 'instant-on' tube doesn't need the warm-up timer on my board, but it
> does benefit from all the other metering and protection features.
>
> The manual actually deals with this point: for 'instant-on' tubes, the
> warm-up delay can be eliminated by changing two components.
>
>
> --
> 73 from Ian G3SEK 'In Practice' columnist for RadCom (RSGB)
> Editor, 'The VHF/UHF DX Book'
> http://www.ifwtech.co.uk/g3sek
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
|