Amps
[Top] [All Lists]

[Amps] Anode clearance and Chassis WANTED

To: <amps@contesting.com>
Subject: [Amps] Anode clearance and Chassis WANTED
From: 2 at vc.net (2)
Date: Mon Jun 16 08:16:16 2003
>I am building a 4-1000A linear and will have 4KV on the anode.  What is 
>the MINIMUM clearance I must have from the anode to the top of the metal 
>cabinet?  It looks like it will be about 1" in my present configuration. 
> Will that be sufficient to prevent any problems?

?  The max-signal peak-V on the anode is a bit less than double the anode 
supply V, or, in this case, a tad under 8kV.  In dry air, 8kV can jump about 
0.31" or 7.8mm.

>I am looking for a chassis 14"x13.25"x3.25".........may have to go to a 
>shorter one if the answer to above question is NO but really need the 
>3.25" for the input tuning box to fit.
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps


Rich, AG6K, 805-386-3734, www.vcnet.com/measures


<Prev in Thread] Current Thread [Next in Thread>