Tune up into 50 ohm load and set the counter to jive with the number listed
in the manual for the frequency in use.
(((73)))
Phil, K5PC
----- Original Message -----
From: <wb8jkr@juno.com>
To: <amps@contesting.com>
Sent: Thursday, July 10, 2003 6:58 PM
Subject: [Amps] Alpha 77 turns counter start point
>
> Does anyone know what the factory setting is for
> the tune turns counter? Is it 000 with the cap set at
> minimum or somewhere else?
>
> The manual shows the intial settings to be approximately
> 100 at 3-5 mhz and 210 at 24-30 mhz. This unit was
> taken apart before I got it so I don't know where the cap
> was set and its not mentioned in the manual.
>
> Mark WB8JKR
>
>
> ________________________________________________________________
> The best thing to hit the internet in years - Juno SpeedBand!
> Surf the web up to FIVE TIMES FASTER!
> Only $14.95/ month - visit www.juno.com to sign up today!
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
|