In auto mode the bandswitch has to be set to the auto position. (Fully anti
clockwise)
The band voltage input of the Icom exiter will then switch the appropriate
filter.
When using a non Icom exiter this has to be done manually, with the band swich
on the 2KL. If that band switch doesn't switch past the 18/21 position there
must be a mechanical stop to prevent that.
Dick PA3DUV
QSK mod for the IC2KL: www.qsl.net/pa3duv
>I have lent my icom ic2kl amplifier and power supply to a friend for
>sweepstakes. He says it doesn't have 10 meter capability, but I
>remember installing the factory-supplied mod kit for 10 meters. In
>fact, I have the instructions for the mod. However, I can't for the life
>of me remember how to switch it to 10meters. He says the band
>switch doesn't go past the "18-21" position.
>
>I always use it with an Icom transceiver, and maybe the Icom
>automatic band tracking feature via the acc cable put it on 10 for
>me, and I never worried about it.
>
>He's using a Kenwood xcvr. Can He use it on 10m? How does one
>switch it manually to 10m?
>
>TIA!
>
>73,
>
>George T. Daughters, K6GT
>
>
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|