** Electric motor rewinding shops carry 180ºC-rated silicone-varnish/ Cu
wire - which is sold by weight on your spool. Bring your own winder.
An electric-drill with a chucked-up rod for the spindle works ok. -
Note: silicone-varnish is best removed with a flame, followed by ash
removal with steel wool.
-cheers
>I'm in need of 18 ga enamel coated wire for winding toroid inductors. I
>used to be able to find it everywhere, however thats not the case today.
>Any suggestions on a location would be greatly appreciated. In the mean
>time are any of the following wire coatings the same as enamel: Heavy
>Amidesten, Heavy Poly Nylon, Polyimide Enamel, or Single Poly Nylon?
>These are coatings used on magnet wire that I am able to find. Would any
>be a suitable substitute? Many thanks in advance for your help.
>Kurt...
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|