Amps
[Top] [All Lists]

Re: [Amps] Rice Box Exciter to Collins 30S-1 & 30L-1

To: Roger Agnew <k1kq@motorhomesusa.com>, amps@contesting.com
Subject: Re: [Amps] Rice Box Exciter to Collins 30S-1 & 30L-1
From: Joe Isabella <n3ji@yahoo.com>
Date: Wed, 7 Jul 2004 06:50:32 -0700 (PDT)
List-post: <mailto:amps@contesting.com>
Hi Roger!!
I've been running "Rice Box" AM for some time now, and the trick is to keep the 
drive below the point that rig distorts.  I know that all the manuals say "40W 
on AM", but I've found that power level includes more distortion than I like to 
see.  If you keep it down below 25W you'll be in great shape.  In fact, I've 
talked to a few guys running the 756 series into an amp and they sound pretty 
good!
 
The only caveat to this is that the amp must also be kept below it's maximum 
PEP level, too.  If you use the 30L-1, that's 1000W PEP or APPROXIMATELY 250W 
carrier on AM.  You'd do well to reduce the 756's output to keep it down to 
around 200-225W or so.  I used to drive a Kenwood TL-922 at about 250-300W 
carrier and it seemed quite happy at that level.  I now have a Henry 3K-A, and 
it will easily go above the APPROXIMATE "legal limit" of 375W carrier on AM.  I 
would bet your 30S-1 is similar in this regard.  I simply reduce the drive 
until I see around that level and all is well.  In case you haven't caught on 
yet, the "rule of thumb" is power out in PEP is approximately equal to AM 
carrier x4.  It totally depends on the audio (sideband) levels coming from the 
exciter.  I hope I'm not insulting you with oversimplified statements!!  Feel 
free to contact me off-line if you want to discuss this more.  BTW, I now run a 
Ten-Tec Jupiter with my Henry for an all made in the USA shac
 k.  I
 guess you could call it a "Wheat Box" instead (??).  :-)
 
Also, I live a little north of you in the DFW area, so we could easily setup a 
sked if you like.  I currently have my shack disassembled, but it will be back 
up by the weekend.
 
Best of luck and 73!!
Joe, N3JI
Lewisville, TX


Roger Agnew <k1kq@motorhomesusa.com> wrote:
I would like to get on an AM Net tomorrow with my Icom 756 Pro driving my 
Collins 30S-1 or 30L-1. Does anyone know or could guide me to a source of 
information to properly drive these amps with the Icom 756 Pro.


Roger Agnew
K1KQ - Austin, TX
888-536-5500

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

                
---------------------------------
Do you Yahoo!?
Take Yahoo! Mail with you! Get it on your mobile phone.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>