Re: [Amps] Recommend supplier for aluminum sheet?

[Harry Brown <harryhbrown@earthlink.net>]

Bill,

The guy at Daytona is likely Charles Byers, K3IWK. He sells antennas and 
aluminum boxes. He does have a web  site but I don;t have it available.

His e mail address is: k3iwk@flash.net

I think he will do custom boxes to your requirements.

Best  of luck.

73, Harry, W3IIT
=======================
At 09:27 AM 9/13/2004 -0400, Bill Fuqua wrote:
> That reminds me. There is a guy every year at the Dayton Hamvention that 
> sells aluminum boxes that he makes himself. Naturally I have no idea who 
> he is or where his outside flea market spot was. He could be a could 
> resource if someone can identify him.
>
> 73
> Bill wa4lav
>
>
> At 12:54 AM 9/13/2004 -0700, Bill Turner wrote:
> > I need some pieces of sheet aluminum for an amp project.  I've done a
> > search on the internet and found a few suppliers who will do custom
> > cutting and sell in small quantities.  OnlineMetals.com has a very
> > good website and would appear to be a good choice.  I'm in Southern
> > California, and closer would be better.
> >
> > Any others you'd care to recommend?
> >
> > Thanks in advance,
> >
> > --
> > Bill W6WRT
> >
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps