| To: | <amps@contesting.com> |
|---|---|
| Subject: | [Amps] 4cx800 for vhf |
| From: | <kc4mne@bellsouth.net> |
| Date: | Mon, 20 Sep 2004 9:14:55 -0400 |
| List-post: | <mailto:amps@contesting.com> |
Hello, Looking to build a single 4cx800 amp for VHF. Any suggestions on a good plate output design. The one in Technical Bulletin 42 from Svetlana seems kind of difficult to tune and the construction details are very poor. Thanks KC4MNE _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Amps] Equalising resistors with HV diodes, peter . chadwick |
|---|---|
| Next by Date: | Re: [Amps] Equalising resistors with HV diodes, DF3KV |
| Previous by Thread: | [Amps] On Thu, 16 Sep 2004 21:54:56 -0700, Leigh S. Jones wrote:>rule 1: never apply plate voltage to the tube nor apply drive power>until after the prescribed filament warm-up period has elapsed_________________kill the B- lead for the HV, Angel Vilaseca |
| Next by Thread: | [Amps] B- switching., craxd |
| Indexes: | [Date] [Thread] [Top] [All Lists] |