[Amps] Equalising resistors with HV diodes

[R.Measures <r@somis.org>]

Begin forwarded message:

> From: R. Measures <r@somis.org>
> Date: September 21, 2004 9:13:54 AM PDT
> To: Joe Isabella <n3ji@yahoo.com>
> Cc: Amps <amps@contesting.com>
> Subject: Re: [Amps] Equalising resistors with HV diodes
>
>
> On Sep 21, 2004, at 8:13 AM, Joe Isabella wrote:
>
> What's the procedure?  Simply connect diodes to the tester at 1300V 
> and only use the ones that don't smoke?   :
> >
--  Put a 5 to 10  meg-ohm R in series with a uA meter in series with 
the high-pot tester.  Connect to the device under test (DUT) and slowly 
increase V until a reverse current of c. 5uA flows.  Stop increasing V 
and record it.  This is what going on in pic20 in the Class A amplifier 
project on my Web site.  
> cheerz, Joe
>
> Richard L. Measures, AG6K, 805.386.3734.  www.somis.org
Richard L. Measures, AG6K, 805.386.3734.  www.somis.org

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps