I apologize for the delay in completing this thread, but life has been very
busy lately. What appeared to be a bad tube, was actually just a bad
contact with the tube socket. The amp had been sitting for some time. I
removed and re-inserted the tubes into the sockets, and everything is
working fine now. I'm getting about 1200-1300W PEP out and am quite happy.
Thanks to all for the advice and thanks Rich for offering to look at the
tube for me.
Clay W7CE
----- Original Message -----
From: "R.Measures" <r@somis.org>
To: "Clay W7CE" <w7ce@curtiss.net>
Cc: <amps@contesting.com>
Sent: Thursday, August 12, 2004 3:45 AM
Subject: Re: [Amps] 3-500ZG brands
>
> On Aug 11, 2004, at 7:04 PM, Clay W7CE wrote:
>
> > I've just acquired a Kenwood TL-922A which needs a new pair of finals
> > (one
> > of the filaments doesn't light up).
>
> Clay -- Please mail me the tube with the open filament. I will repair
> it if possible, or, if not, autopsy it and post the picture of the guts
> on my Web site.
>
> > Does anyone have experience using the
> > Taylor or RF Parts branded 3-500ZG tubes in this amp? Does the
> > cathode bias
> > need to be changed when switching to the 3-500ZG?
>
> Not if the ZSAC is 75mA to 90mA per tube. However, the stock 7.5v
> zener in the 922) will usually be too much bias V. -- i. e., not
> produce enough ZSAC.
> - end
>
> > Any recommendations will
> > be appreciated.
> >
> > Thanks,
> > Clay W7CE
> >
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> >
> >
> Richard L. Measures, AG6K, 805.386.3734. www.somis.org
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|