3200v on a 4CX250 is kind of scary....usually you need a ~ 5:1 ratio of
plate to screen voltage for linear operation with this series, and that
would be ~600v on the screens. Yikes! -WB2WIK/6
"Nobody needs more than 640k!" -Bill Gates, 1982
> -----Original Message-----
> From: R.Measures [SMTP:r@somis.org]
> Sent: Tuesday, October 12, 2004 2:35 PM
> To: George
> Cc: amps@contesting.com; Chris Pedder
> Subject: [BULK] - Re: [Amps] Looking for a design for a single
> 4cx250b tube on50 Mhz-six meters.
>
>
> On Oct 12, 2004, at 2:15 PM, George wrote:
>
> > In about 1965 I ran a pair of 4CX250R's at 3200 VDC and proved to a
> > friend
> > of mine that they would put out 750 to 800 watts on 6 meters.
>
> George -- How much screen V?
>
> >
> > They got hot
> > on long transmissions ..,in fact, the plate leads unsoldered and I had
> > to
> > clamp them. This was the time you could buy these rugged ceramics for
> > 1.00
> > each in the L.A., CA military surplus market. Didn't care if they
> > croaked,
> > as they were cheap.
> >
> > Regards,
> > George W7LFD...ex W6BFJ
> >
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> >
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> >
> >
>
> Richard L. Measures, AG6K, 805.386.3734. www.somis.org
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|