Re: [Amps] Gaussmeter needed

[Will Matney <craxd1@ezwv.com>]

Bill,

I should have mentioned that was gauss per sq inch. I figure some of the 
older ones may have measured it this way. Actually, I need one that will 
measure something like 10-20 kilogauss per sq cm. I want to use it here 
for transformer lam stacks to check the gauss against factory specs. It 
could be either AC or DC, AC for transformers and DC for chokes. The 
precision can be within +/- 5-10% or so, or a few gauss (10 to 20). It 
doesn't have to be that exact as I figure older ones won't have a tight 
tolerance anyhow. I found an old FW Bell on Ebay but the guy never 
e-mailed me back to tell me how high it would measure.

Will Matney


Bill L. Fuqua wrote:

> A few questions.
> Do you need one for ac or dc fields (most likely DC at that level). What is the 
> gap size?  What level of precision?  what is the area you are trying to measure 
> the field?
>
> 73
> Bill wa4lav
>
> -----Original Message-----
> From: Will Matney <craxd1@ezwv.com>
> To: "amps@contesting.com" <amps@contesting.com>
> Date: Sat, 16 Oct 2004 23:40:19 -0400
> Subject: [Amps] Gaussmeter needed
>
> I'm looking for a good used gaussmeter that will read at least 50 to100 
> kilogauss. I've looked around on Ebay and most listed are without the 
> probe making them useless. Most times, a new probe, if still available, 
> would cost way more than what the meter is worth. If anyone has an old 
> one that they're wanting to sell, please contact me. Thanks in advance.
>
> Will Matney
>
> craxd1@ezwv.com
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
>
>
>
> __________ NOD32 1.880 (20040928) Information __________
>
> This message was checked by NOD32 antivirus system.
> http://www.nod32.com
>
>
>
>  

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps