On Nov 3, 2004, at 1:33 AM, QSKguy@aol.com wrote:
Hi all.
I would like to read PEP on my Bird 43.
To accurately read PEP, one needs to use that which is used to
calibrate PEP wattmeters -- i. e., a calibrated oscilloscope, a HV RF
probe, and a 50-ohm termination.
I found some kits on the web :
_http://www.lnatechnology.com/lnatech_039.htm_
(http://www.lnatechnology.com/lnatech_039.htm)
_http://www.tomstubes.com/kits.htm#PEP_
(http://www.tomstubes.com/kits.htm#PEP)
_http://home.att.net/~hi-res/Kits/PDC-1/pdc-1.html_
(http://home.att.net/~hi-res/Kits/PDC-1/pdc-1.html)
All of these kit seem to have the same components, they probably use
the
same schematic.
These kits are not really expensive but ordering from France is always
difficult.
So the question is : do you now where I can find this schematic ?
The only one I found is the K0XP one but I want to continue using my
different bird plugs.
Thanks a lot.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
Richard L. Measures, AG6K, 805.386.3734. www.somis.org
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|