Paul,
I would think it a possibility. Since you dont have a vacuum relay in there, I
assume the contacts are cleanable?
Will
*********** REPLY SEPARATOR ***********
On 3/9/05 at 7:49 AM Paul B. Peters, VE7AVV wrote:
>My TL-922 has most of the mods suggested by Rich, AG6K -- but one item
>that
>has not been done is the vacuum relay QSK.
>
>I tell you this by way of introduction to the symptoms I have noticed in
>the
>last few days. The amp operates perfectly with one minor exception.
>Regardless of whether I'm operating with the foot switch or VOX, the amp
>seems to hang for a second when I unkey or stop talking. By hang I mean,
>the
>amp is definitely not transmitting, but I don't have complete audio back in
>the headset -- the audio sounds a bit ragged for a second or two and then
>all is fine once again. Could this be an early indicator of a failing TX
>relay?
>
>73 de Paul, VE7AVV
>StoneyGround Station
>-||<*><*>||<*><*>||<*><*>||<*><*>||<*><*>||<*><*>||-
>"All email from this address is checked by Norton AntiVirus"
>
>
>
>
>_______________________________________________
>Amps mailing list
>Amps@contesting.com
>http://lists.contesting.com/mailman/listinfo/amps
>
>
>__________ NOD32 1.999 (20050215) Information __________
>
>This message was checked by NOD32 antivirus system.
>http://www.nod32.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|