Amps
[Top] [All Lists]

[Amps] RENEGADE CUSTOM 300B

To: AMPS@CONTESTING.COM
Subject: [Amps] RENEGADE CUSTOM 300B
From: JAMES SMITH <kg6nlb@yahoo.com>
Date: Sat, 21 May 2005 14:46:54 -0700 (PDT)
List-post: <mailto:amps@contesting.com>
REGARDING A NEWLY ACQUIRED 6 METER 
AMP THAT COVERS 1.8 TO 53 MHZ BUT IS NOT WORKING TO IT'S FULLEST 
EXTENT. I HAVE SOME KNOWLEDGE BUT AM STILL A AMATUER. IT WAS TAKEN TO A HAM 
REPAIR SHOP AND THE TECH WAS ABLE TO TELL ME THAT THE PROBLEM WAS 
PROBABLY IN THE TANK PORTION OF THIS AMPLIFIER BUT COULDN'T TELL WHAT EXACTLY 
WAS WRONG BECAUSE OF THE LACK OF SCHEMATICS. IT IS A VERY SIMPLE AMPLIFIER 
USING 2 3-500Z'S. IT ONLY PUTS OUT 400 WATTS PEP AND FROM WHAT OTHERS TELL ME 
IT SHOULD PRODUCE 1200-1500 WATTS PEP WITH APPROXIMATELY 100-150 WATTS OF 
DRIVE. IM NOT SURE IF IT IS A NORMAL CONDITION BUT IT ARC'S ACROSS THE TUNING 
CAPS WHEN UNKEYED LIKE STORED VOLTAGE. I CAN'T SEE THE COLORS OR THE RESISTORS 
THAT GO TO THE TOP OF THE TUBES I WAS JUST GOING TO START REPLACING THINGS BUT 
FIGURED THAT IF SOMEONE MIGHT BE ABLE TO LEAD ME IN THE RIGHT DIRECTION IT 
WOULD MAKE THINGS A LOT LESS TIME CONSUMING. THE TECH DID TEST THE TUBE'S THEY 
TESTED AT 90-95%. ALTHOUGH I DID HAVE ANOTHER BRAND NEW SET I STUCK IN JUST IN 
CASE AND STILL THE SAME. I DO PLAN ON RE-WIRING IT AS SOON AS I CAN BECAUSE 
SOME OF THE SOLDER JOINTS LOOKS PRETTY BAD. IT HAS TWO TRANSFORMERS AND IM 
THINKING THAT ITS A GOOD POSSIBILITY THAT ONE IS GOING BAD AND TH
 AT 
VOLTAGE SUPPLY IS AN ISSUE. ONE SUPPLIESW VOLTAGE TO THE TOP OF THE TUBES AND 
THE OTHER SUPPLIES VOLTAGE TO THE BOTTOM OF THE TUBES. THREE OF THE TUBES ARE 
SHORTED TO CHASSIS GROUND. IT ALSO HAS A BANDCOIL AND NOT A SWITCH TO GO FROM 
6, 10, 12, 15, 20, 40, 80 METERS SO YOU CAN REALLY 
FINE TUNE. IF YOU COULD HELP I WOULD BE VERY GREATFUL. I ALSO UNDERSTAND 
THAT THEY ARE VERY DANGEROUS TO WORK ON IF NOT EXPERIENCED. I KNOW 
BETTER THAN TO STICK MY FINGERS IN UNLESS IT IS DISCHARGED. IF YOU COULD 
GIVE ME A REFERENCE VOLTAGE AT A COUPLE OF PLACES I COULD CHECK THE 
VOLTAGES AND REFER BACK TO YOU FOR FURTHER ASSISTANCE. OR I COULD TAKE 
PICTURES AND POST THEM WITH AN E-MAIL SO YOU COULD SEE THE DESIGN. OR IF YOU 
CAN'T HELP ME MAYBE YOU CAN REFER ME TO A REPAIR SHOP THAT CAN 
DEFINATELY FIX THE THING. DUE TO IT'S WEIGHT I'D RATHER NOT SHIP IT THOUGH. 
ANY HELP WOULD BE GREATLY APPRECIATED. KG6NLB@YAHOO.COM JAMES SMITH @ 
209-329-3826 YOU MAY CALL IF IT WILL BE EASIER OVER THE PHONE ALSO.


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>