Amps
[Top] [All Lists]

Re: [Amps] 100 microhenry inductor

To: barrie@centric.net, amps@contesting.com
Subject: Re: [Amps] 100 microhenry inductor
From: "wc6w@juno.com" <wc6w@juno.com>
Date: Wed, 21 Sep 2005 17:13:15 GMT
List-post: <mailto:amps@contesting.com>
Hi Barrie,
  B&W used to make a model 3853 which was 72 uH.  Close enough?

  There is also a surplus piece, which I've seen a few exemplars go by over the 
years.  It has large, circa 8" x 10" ceramic end plates with an approx. 4" 
diameter by 10" long coil mounted toward one corner of the plates.  I vaguely 
recall figuring it at over 100uH long, long ago.  You might troll for one on... 
Ebay. 

  Neither of these are wound with particularly large wire... perhaps #16?

73 & Good morning,
  Marv WC6W

-- "Barrie Smith" <barrie@centric.net> wrote:
Hello All:

For an antenna project, I have need for a 100 microhenry adjustable inductor.

I can wind one, and provide taps throughout.  However, I'm wondering if there 
is such a thing as a 100 microhenry rotary inductor.

And, if there is, where would I find one?

73, Barrie, W7ALW
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps



___________________________________________________________________
Try Juno Platinum for Free! Then, only $9.95/month!
Unlimited Internet Access with 250MB of Email Storage.
Visit http://www.juno.com/value to sign up today!

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>