I recently got a Drake L-4B amplifier. I've been using (abusing) it a
couple of weeks on CW on the high voltage SSB position. Pretty much
everybody seems to do this. After all, it's only running 2500 volts on
the anodes and they just glow a dull red when I'm keying.
Yesterday, in the middle of a QSO, the short circuit protection resistor
(R12) in the power supply gave an impressive firework display and
expired.
First question: has anyone seen this 2 watt component fail under
"normal" use before? The nominal 0.82 ohm value would have to have
drifted very high for it to fail at a load current of well under 1 amp.
Is there an underlying fault that I should go look for?
Second question: the manual is very explicit that only an IRC type BWH
resistor should be fitted. Can someone help with a translation of what
this specification means, so I can buy an equivalent here in the UK?
--
Cheers,
Alan G3XAQ
alan@g3xaq.demon.co.uk
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|