Amps
[Top] [All Lists]

Re: [Amps] sb-200 HIGH swr on output- HELP!

To: anewell@alltel.net
Subject: Re: [Amps] sb-200 HIGH swr on output- HELP!
From: HAROLD B MANDEL <ka1xo@juno.com>
Date: Mon, 21 Nov 2005 22:28:00 -0500
List-post: <mailto:amps@contesting.com>
It sounds like your T/R relay contacts are dirty. That's the
first place I'd check. If it's an open frame relay it's probably the
culprit.

For testing purposes always use a dummy load.

Keep the other hand in your pocket.


Hal
W4HBM
On Mon, 21 Nov 2005 22:10:56 -0500 ashley newell <anewell@alltel.net>
writes:
> hi all,
> i have an sb-200, that has all the harbach mods etc., that has been 
> in 
> storage for a few years.
> i hooked it up to my station, and with a small amount of drive, the 
> 
> output swr is off the scale!!
> with the amp turned off, and signal running through it, i have abt a 
> 1.4 
> to 1, which is the antenna swr.
>  any help?
> 
> de kn4nn
> -- 
> 
>
=========================================================================
=======
> 
>   J. ASHLEY NEWELL                          
> 
>   anewell@alltel.net
> 
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 
> 


Harold Mandel
Const. Supt.
Baran/Greenville
606 - 205 - 0172
hmandel@barantelecom.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>