Thought I would throw this out to the group and see if anyone can offer up
some help.
The amp I am working on is an old Transworld amp (the RA-1000). No schematic
is available. Just installed 4 new MRF448 (2 matched pairs).
The amp uses 2 boards with 2 devices per board.
Power supply voltage is 40V dc
When I test it I can only get max 200W out (should be good for 800 or more).
Amp has metering for collector current for both boards. Each shows 10A when
transmitting.
Any ideas on what I should be looking for? If I read the data sheet
correctly the bias voltage should be 4V. Am I correct?
Any help will be appreciated.
Thanks
Ron
N4XD
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.362 / Virus Database: 267.13.5/178 - Release Date: 11/22/2005
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|