Bob,
Lawson Summerrow, W4EMF, did a very nice conversion of the MLA-2500 to a
pair of 3CX800A7s. A few pictures can be seen here:
<http://w4emf.gs35b.com/mla2500-retro-3cx800/>
There's no other info available on that retro but the pictures should
give you enough to decide whether you want to take it on.
73, Tony W4ZT
k6zz@mail.ccis.com wrote:
> Hi Folks,
>
> I could use some advice on the MLA-2500 power supply. I'm
> planning to put a pair of 3CX800A7's in a tubeless but
> otherwise very good condition MLA-2500. It seems like a
> straightforward modification, but I am somewhat concerned
> about comments I have seen regarding the ability of the
> power supply to handle these tubes. What is it about these
> particular tubes that would put an extra strain on the power
> supply? If they aren't driven any harder than the original
> 8875's or a pair of 8874's, what difference would it make?
> I could use different tubes but I happen to have a good pair
> of 3CX800A7's so I'm inclined to move forward if the power
> supply can handle it.
>
> I have no desire to push the modified amplifier to power
> levels beyond its capacity, but I would like to comfortably
> run the amp at the legal limit if the power supply and tank
> circuit can handle it.
>
> Have you done this particular modification before? Is the
> power supply up to the task? If not, what can be done to
> improve its shortcomings?
>
> 73, Bob K6ZZ
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|