Fwiw, its not whitworth thread either. If my aged memory is correct all
whitworth was 18 tpi regardless of the diameter of the bolt or cap screw in
question.
This is a new one on me too.
73,
Gary...wa6fgi
----- Original Message -----
From: "Will Matney" <craxd1@verizon.net>
To: <amps@contesting.com>
Sent: Monday, March 13, 2006 9:35 AM
Subject: Re: [Amps] Proof of idiocy
> I've never seen nor heard of a 1/4-23 thread. The standards are 1/4-20 NC,
> and 1/4-28 NF. I don't know of a lathe that would turn that either without
> a special gear being made for the feed, if that's even possible over the
> ratios. If it was odd-ball size, the thread dial might not be usable to
> know when to throw in the half-nut lever. Most lathes are set up to turn
> either standard inch or metric threads. I would think that the shaft of
> those caps would be turned in a lathe or a screw machine. I did a google
> search for 1/4-23 and came up with nothing.
>
> Best,
>
> Will
>
> *********** REPLY SEPARATOR ***********
>
> On 3/13/06 at 8:50 AM R; Measures wrote:
>
>>On Mar 13, 2006, at 4:43 AM, HAROLD B MANDEL wrote:
>>
>>> It is possible that the threads are bunged on the
>>> leadscrew or the collar, but good luck locating
>>> a tap or die!
>>>
>>> These threads are Jennings proprietary pitch
>>> and once fouled there is no way to chase them
>>> or to re-cut.
>>
>>The threads are 1/4 - 23 -- for which taps and dies are available.
>>>
>>> The alternative is to substitute pieces from
>>> another vacuum variable and hope for the
>>> best.
>>>
>>> If the junction that pulls the bellows on the
>>> room-pressure side is gone and the threads are
>>> still good then the piece can be used for the collars
>>> and lead screw threading.
>>>
>>> Allen Bond and Economy sell very decent vacuum
>>> variables to the amateur. I have bought several
>>> ceramic and glass types from each. The most important
>>> feature is that both of these businesses HiPot each
>>> item before it ships and will not send a DOA or
>>> leaky variable.
>>>
>>> Buyer Beware: Things seeming to be too good to be
>>> true often are.
>>>
>>> Hal
>>> W4HBM
>>>
>>>
>>>
>>>
>>> On Sun, 12 Mar 2006 19:35:08 -0500 "Will Matney" <craxd1@verizon.net>
>>> writes:
>>>> $148 and gowing on! The only usable piece looks to me like would be
>>>> the flange on the rear. The high bidder now looks to be an
>>>> engineering firm......
>>>>
>>>> http://cgi.ebay.com/Jennings-Vacuum-Variable-Capacitor-5-kV-9-500-
>>>> pF_W0Q
>>> QitemZ7597842893
>>> _______________________________________________
>>> Amps mailing list
>>> Amps@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/amps
>>>
>>>
>>
>>
>>
>>Rich Measures, 805.386.3734, AG6K, www.somis.org
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|